Filter
Top Products
20
CONVERGENCE (CONVERGE RED/BLUE)
Due to the influence of magnetic fields and changes in the position of the TV, the red, blue, and
green screen colours may not align properly. The result is that red or blue colours may
appear around the edges of images. If various images on the entire picture have red outlines,
adjust CONVERGE RED. Then if any red outlines remain, adjust MULTIPOINT RED. If
various images on the entire picture have blue outlines, adjust CONVERGE BLUE. Then if
any blue outlines remain, adjust MULTIPOINT BLUE. Use UNDO MULTIPOINT if you
want to restore the picture screen to the way it was before you made Multipoint adjustments.
Note
• After turning the TV set on, allow it to warm up for 15 minutes before adjusting Convergence.
• If you adjust Convergence and then change your signal source from PAL to NTSC or from
NTSC to PAL, you may need to readjust Convergence for the new signal source.
1. Enter main menu.
2. Enter PICTURE menu.
3. Press button repeatedly
until CONVERGENCE
is selected.
4. Enter CONVERGENCE
menu.
5. Enter CONVERGE
RED mode.
6. Adjust cross image until
colour outline is gone.
7. Exit menu from screen.
Note: You can adjust CONVERGE BLUE similar to the way you would adjust
CONVERGE RED.
PICTURE
•
HUE
•
COLOUR TEMP
•
NR
•
INCR. PICTURE
•
CONVERGENCE
CONVERGE RED
CONVERGE BLUE
MULTIPOINT RED
MULTIPOINT BLUE
SAVE MULTIPOINT
•
•
PICTURE
CONVERGENCE
•
CONVERGE RED
•
•
CONVERGE BLUE
•
MULTIPOINT RED
•
MULTIPOINT BLUE
•
SAVE MULTIPOINT
•
•
CONVERGE RED
•
CONVERGE RED
PICTURE
•
HUE
•
COLOUR TEMP
•
NR
•
INCR. PICTURE
•
CONVERGENCE
CONVERGE RED
CONVERGE BLUE
MULTIPOINT RED
MULTIPOINT BLUE
SAVE MULTIPOINT
•
•
•
CONVERGE BLUE
•
CONVERGE BLUE
PICTURE
CONVERGENCE
•
CONVERGE RED
•
CONVERGE BLUE
•
•
MULTIPOINT RED
•
MULTIPOINT BLUE
•
SAVE MULTIPOINT
•
É
▲
▲
MENU
OSD