Filter
Top Products
21
CONVERGENCE (MULTIPOINT RED/BLUE)
If various images on the entire picture have red outlines, adjust CONVERGE RED. Then if
any red outlines remain, adjust MULTIPOINT RED. If various images on the entire picture
have blue outlines, adjust CONVERGE BLUE. Then if any blue outlines remain, adjust
MULTIPOINT BLUE. Use UNDO MULTIPOINT if you want to restore the picture
screen to the way it was before you made Multipoint adjustments.
Note
• After turning the TV set on, allow it to warm up for 15 minutes before adjusting
Convergence.
• You can use Multipoint Red and Multipoint Blue controls to adjust 25 Convergence points
on the screen.
• If you adjust Convergence and then change your signal source from PAL to NTSC or from
NTSC to PAL, you may need to readjust Convergence for the new signal source.
1. Enter main menu.
2. Enter PICTURE menu.
3. Press button repeatedly
until CONVERGENCE
is selected.
4. Enter CONVERGENCE
menu.
5. Press button repeatedly
until MULTIPOINT
RED is selected.
6. Enter NAVIGATE
mode.
PICTURE
•
HUE
•
COLOUR TEMP
•
NR
•
INCR. PICTURE
•
CONVERGENCE
É
▲
▲
CONVERGE RED
CONVERGE BLUE
MULTIPOINT RED
MULTIPOINT BLUE
SAVE MULTIPOINT
•
•
PICTURE
CONVERGENCE
•
CONVERGE RED
•
•
CONVERGE BLUE
•
MULTIPOINT RED
•
MULTIPOINT BLUE
•
SAVE MULTIPOINT
•
É
▲
▲
PICTURE
CONVERGENCE
•
CONVERGE RED
•
CONVERGE BLUE
•
MULTIPOINT RED
•
•
MULTIPOINT BLUE
•
SAVE MULTIPOINT
•
É
▲
▲
•
NAVIGATE
OSD: ADJUST
MENU