Philips 75/021 DVD Recorder User Manual


 
7
Important
Caution:
Visible and invisible laser radiation. If the cover is open, do not look at the beam.
Because of the risk of eye injuries, only qualified service engineers should open the machine and
carry out maintenance or repair work.
LASER
Type: Semiconductor lasers InGaAlP (DVD), AlGaAs(CD)
Wavelength: 660nm (DVD), 780nm (CD)
Output power (outside the lens): 20mW (DVD+RW write), 0.8mW (DVD read), 0.3mW (CD
read).
Beam divergence: 82 degrees (DVD), 54 degrees (CD)
Danger. High voltage! Do not open.
You run the risk of getting an electric shock.
The machine does not contain any user-serviceable parts. Please leave all maintenance work to
qualified personnel.
There are some components in the DVD recorder that keep running as long as the recorder is
connected to the power supply. To switch off the DVD recorder completely you must unplug it
from the power supply.
If you disconnect the DVD recorder from the mains, make sure to take the plug out of the wall
socket and not just remove the connector from the 4MAINS socket at the back of the unit.
Children could seriously injure themselves as the free end of the cable may still be live.
These operating instructions have been printed on non-polluting paper.
Please dispose of old batteries safely.
Please take the packaging to your local recycling centre.
This electronic equipment contains a large number of materials that can be recycled. If you are
disposing of an old machine, please take it to a recycling centre.
ENGLISH
Introduction