Filter
Top Products
EN
EN - 5
Ⅲ Cleaning the Disc Lens
• If this unit still does not perform properly although you
refer to the relevant sections and to
“TROUBLESHOOTING” in this user manual, the laser
optical pickup unit may be dirty. Consult your dealer or
an Authorized Service Center for inspection and
cleaning of the laser optical pickup unit.
Ⅲ Disc Handling
• Handle the discs so that fingerprints and dust do not
adhere to the surfaces of the discs.
• Always store the disc in its protective case when it is
not used.
• Note that discs with special shapes (heart-shaped discs,
octagonal discs, etc.) cannot be played back on this unit.
Do not attempt to play such discs, as they may damage
the unit.
Ⅲ Testing the Remote Control
• If the remote control is not working properly, you can
use a digital camera (including a cellular phone with
built-in camera) to see if it is sending out an infrared
signal.
How to perform the test?
1.3. Notice
Specifications are subject to change without notice.
Trademarks are the property of Koninklijke Philips
Electronics N.V. or their respective owners. P&F USA
reserves the right to change products at any time without
being obliged to adjust earlier supplies accordingly.
The material in this manual is believed adequate for the
intended use of the system. If the product, or its individual
modules or procedures, are used for purposes other than
those specified herein, confirmation of their validity and
suitability must be obtained. P&F USA warrants that the
material itself does not infringe any United States patents.
No further warranty is expressed or implied. P&F USA
cannot be held responsible neither for any errors in the
content of this document nor for any problems as a result
of the content in this document. Errors reported to P&F
USA will be adapted and published on the P&F USA support
website as soon as possible.
Ⅲ Warranty
No components are user serviceable. Do not open or
remove covers to the inside of the product. Repairs may
only be done by Service Centers and official repair shops.
Failure to do so shall void any warranty, stated or implied.
Any operation expressly prohibited in this manual, any
adjustments, or assembly procedures not recommended or
authorized in this manual shall void the warranty.
1.4. Important
Registering your model with Philips makes you eligible for
all of the valuable benefits listed below, so don’t miss out.
Complete and return your Product Registration Card at
once, or register online at www.philips.com/support to
ensure :
Product Safety Notification
By registering your product you receive notification
- directly from the manufacturer - in the rare case of a
product recall or safety defect.
Additional Benefits of Product Ownership
Registering your product guarantees that you receive all of
the privileges to which you’re entitled, including special
money-saving offers.
For further assistance
For further assistance, call the customer support service in
your country.
• To obtain assistance in the U.S.A., Canada, Puerto Rico,
or the U.S. Virgin Islands, contact Philips Customer
Care Center at 1-866-309-0866
1. Point the IR transmitter of the
remote control towards the lens of
the digital camera (or cell phone
camera).
2. Turn on the digital camera and
look at the IR transmitter of the
remote control through the LCD
display of the digital camera.
3. While looking at the LCD, press
the buttons on your remote
control you want to test.
a. If your remote control is
working properly, the IR
transmitter of the remote
control will create a noticeable
flash on the LCD of the digital
camera.
b. If it does not flash, replace the
batteries in your remote with
new batteries and try again. If it
still does not flash, your
remote control may be
damaged or defective. Please
contact customer service for
replacement options.
E5WA0UD_EN_v3.book Page 5 Thursday, March 24, 2011 1:43 PM