Filter
Top Products
English
Assuming the settings of your receiver and recorder (refer to your VCR or DVD recorder user
manual) are done, to perform a recording you shall:
- Program a timer with your receiver (refer to section 4.9)
- Put your recorder in the appropriate status to be controlled by your receiver (refer to the VCR
or DVD recorder user manual).
At timer occurrence your recorder shall start and stop recording automatically.
Note: While the recording is in progress, your receiver is protected from inadvertent action to disrupt the
recording. Please note that during the recording the "rEc" label is displayed on the front panel display. To
cancel the running recording, press
EEXXIITT
. This brings up a small window prompting you for confirmation. To
cancel the recording, press
OOKK
.
7.2 Change the Remote Control and receiver "Device" Settings
If you have other equipment in your home and the Philips remote control of your digital receiver
interferes with them, you can change the setting of your remote control and the setting of your
receiver as well. By default, your receiver is recognized as Device 1 and the remote control is set
to control Device 1. You may change this identifier to Device 2 using the System Settings screen
from the Settings submenu. Please note however, that you will also have to change the remote
control setting in order to be able to control Device 2.
To change the setting of your remote control, proceed as follows:
1 Make sure that the remote control is in the STB mode (Press Mode button, the STB LED shall
blink, if a different LED does, press the Mode button as many time as necessary to get STB LED
blinking).
2 Press number keys 1 and 3 simultaneously and hold them until LED blinks twice.
3 Release these two keys. The STB LED is still on to indicate that the remote control is in the
programming mode.
4 Enter the new code setting within 60 seconds (the LED is blinking once after each digit entry):
Either 0048 for Device 2 or 0038 for Device 1 (factory setting).
Alternatively you may reset your remote control to its default setting (Device 1) by removing the
batteries and waiting for more than 3 minutes to re-insert them.
34 ADVANCED SETTINGS
6610_A5_GB.qxd 01/09/2004 12:58 Page 34