Filter
Top Products
DVD to Videotape Duplication
39
Follow the steps below to copy a DVD to a videotape. This will
be possible only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the
tape’s record tab is intact and the tape is long enough to record
the DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so the green VCR light appears on the front of the
DVD/VCR.
● Turn on the TV.
1
Point the remote control at the DVD/VCR. Press Number
buttons 0, 0, 3.“DISC” will appear on the TV screen.
2
Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the screen. Details about tape
speed are on page 76.
3
Press RECORD
I
to start recording. The red RECORD
light will appear on the front of the DVD/VCR.
4
Press DVD. Press
PLAY B
to play the disc.
5
To pause the recording, press VCR, then press PAUSE
k
once. The red RECORD light will flash. To r esume
recording, press RECORD
I
or press PAUSE
k
again.
The red RECORD light will come on again.
6
To stop recording, press VCR, then press STOP
C
.
DISC
3,5
6
1
5
2
4
5,6
STANDBY-ON
PLAY
VCR/TV
VCRDVD
OK
MENU MENU
SYSTEM
RETURN TITLE
A-B
CLEAR/RESET SLOW
SUBTITLE ZOOM
ANGLE
REPEAT REPEAT
AUDIO
SEARCH MODE
DISPLAY
SKIP / CH
DISC/VCR
PAUSESTOP
VCR Plus+ RECORDTIMER SET
SPEED
1 2 3
7
6
5
4
8
9
0
+10
• A timer recording is not possible
during DVD to videotape
duplication.
•You cannot copy a DVD to a
videotape if you are using
Progressive Scan. Details are on
page 12.
Helpful Hints
H9421CD/DVD750(EN).pgs1-51.QX3 03.4.11 11:29 AM Page 39