Filter
Top Products
English
11
Connections
IMPORTANT!
– The type plate is located at the rear of
the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all other
connections have been made.
–Never make or change any
connections with the power switched on.
– The voltage selector located at the
bottom of this system is preset at
220V-240V from the factory. For
countries that operate at 110V-127V,
please adjust to 110V-127V before you
switch on the system.
To avoid overheating of the system, a
safety circuit has been built in. Therefore,
your system may switch to Standby
mode automatically under extreme
conditions. If this happens, let the system
cool down before reusing it (not available
for all versions).
Step 1: Placing speakers
Front
speaker
( left )
Front
speaker
( right )
VIEWING AREA
Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
Notes:
-To avoid magnetic interference, do not position the
front speakers too close to your TV set.
-Allow adequate ventilation around the DVD
System.
3
SUB
WOOFER OUT
AUX/
CDR IN
R
LINE OUT
DIGITAL
OUT
L
RL
+
R
+
L
SPEAKERS 6Ω
FM 75Ω
FM/MW ANTENNA
AM ANTENNA FM ANTENNA
speaker
(right)
speaker
(left)
3
LINE OUT
DIGITAL
OUT
RL
AC power cord
FM wire
antenna
AUDIO
IN
S-VIDEO
IN
VIDEO IN
AUDIO
IN
S-VIDEO
IN
VIDEO IN
TV IN
5
Cr
Cb
Y
MW loop
antenna
pg001-pg040_MCD510_21-Eng 2005.10.28, 9:2511