Filter
Top Products
5
EN
5.
5.Insert AC cable into the wall socket.
6.
6.If the connection was properly made and
your TV was automatically switched to the
programme number for the scart socket, you
will see the following picture:
Then, read the paragraph 'Preparation for use' in
the chapter 'Installing your video recorder'.
Connecting without a scart cable
Have the following cables ready:
an aerial cable.
1.
1.Switch off your TV set.
2.
2.Remove the aerial cable plug from the aerial
input socket of the TV set. Insert it into the
AERIAL at the back of the video recorder.
3.
3.Insert one end of the
supplied aerial cable
into the RF OUT at
the back of the video
recorder and the
other end into the
aerial input socket at the back of the TV set.
4.
4.Insert AC cable into the wall socket.
5.
5.Switch on your TV set and select the pro-
gramme number used for video playback on
your TV set (see your TV's operating instruc-
tions).
6.
6.Select this programme number and manually
start the TV's channel search as if you want-
ed to save a new TV channel until the 'test
image' appears.
7.
7.Save this programme number setting on your
TV set for video recorder operation.
You can find more details in chapter 'Preparation
for use'.
AERIAL
RF O
UT
TV
AERIAL
RF OUT
RF O
UT
T
V
AER
IA
L
PLEASE CONNECT AERIAL OR
CABLE TO THE VCR
THEN...
PUSH P
+ KEY
OR...
FOR PLAY ONLY - PUSH PLAY
I do not see the picture.
* Check the cable connections.
* Repeat the channel search on your TV.
Programme number for video recorder oper-
ation
You have now saved a programme number for
use by your video recorder as you would a reg-
ular TV channel. This programme number must
now be used in future for video recorder play-
back ('video recorder' TV channel).
PLEASE CONNECT AERIAL OR
CABLE TO THE VCR
THEN...
PUSH P
+ KEY
OR...
FOR PLAY ONLY - PUSH PLAY
My screen is empty
* Many TV sets are switched to the programme
number for the scart socket by way of a control
signal sent through the scart cable.
* If the TV set does not automatically switch to
the scart socket programme number, manually
change to the corresponding programme num-
ber on your TV set (see your TV's operating
instructions).
My TV has several scart sockets.Which one
should I use?
Select that scart socket which is suited for the
video output as well as for the video input.
My TV offers me a selection menu for the
scart socket.
Select 'TV' as a connection source of this scart
socket.
VR330/07.qx3 02.2.6 10:10 AM Page 5