Filter
Top Products
!
your TV remote can be set to
ork various accessory
devices (VCRs, Cable Converters,
Satellite Receivers) by what is
called the SEARCH method.
Note: The Search Method only
works with devices equipped with
Channe! Display Indicators or
capability. If the "Direct Access"
code number method (shown in
the previous section) did not set
your remote to work your
accessory device, then follow the
easy steps listed below.
Turn ON the desired device.
Press the _orYect VCR or ACC
system button on the remote.
_ Stand least six feet
at
away
from the front of the acces_ry
device. Point the remote toward
the unit. HOLD DOWN the
SURF and the desired System
(VCR or ACC) buttons at the
same time. KEEP HOLDING
BUTTONS DOWN,
<_ Watch the Channel Indicator
on the unit, Channe3 Numbers will
SCAN UP when the unit has been
identified. This may take up to
two minutes.
_ Release the SURF and System
(VCR or ACC) buttons as soon
as channel numbers start to scan
up. The code has been identified
and the remote is ready 'to operate
with the accessory device,
O
Remember, a minute or two
ij ea_ seam very long, but the
code should be located within two
minutes.
Don't let the accessory device scan up
more than fi'Je channels. The remote
may pass up the right code and another
two mi_autesearch cycle will have to
be repeated,
If no channel change happens within
tyro minutes, repeat steps 1-4. Should
a channel change still not occur, the
remote wil! not work with the desired
unit.
VCR
SATELLITE RECEIVER
091
Don't let the Accessory Device
®®®
®®®
Six Feet
(minimum)
1
I Nol_: For TV's equipped
with a backllsht option, the unit may
"b_k" or flash as the remote moves
thmu_a it_ 9_exl_c_rode I_sl.Once a
product code has bee_ identirte4 a_ti
the bultons oll _e remote are
released, the _ai_ will blink twice.
4e