Filter
Top Products
yhur Cable TV input into your
ome may be a single (75
ohm) cable, or a Converter Box
installation. In either case the
connection to the 71/is very easy.
Just put the threaded end of the
cable signal to the TV's antenna
plug and screw it down tight.
<_Ifyour Cable TV signal a
is sin-
gle round cable (75 ohm) then
you're ready to connect to the TV.
If you have a Cable Converter
Box:
Connect the Cable TV signal to the
Cable Signal IN(pu0 plug on the
Converter..
<_ the Cable TV cable the
Connect to
75_1plug on the TV.
If you have a Cable Converter Box:
Connect the OUT(pat) plug fromthe
Converter to the 75'_ plug on the TV.
O
i
I
Remember: !
Set the TV for the
type signal you've
just connected (see
the "Tuner section
on page 11 of this
manual.)
To select only the
channel numbers on
your Cable system
see "Auto Program"
(page 12). If you use
a Cable Converter
box, set the TV to the
same channel as the
converter's CH 3/4
switch (on the rear of
the converter.)
Cable TV Company
75,Q
75_) Ohm
Cable TV Converter
Box Connection
v,0E0
IN
Auolo _1