Filter
Top Products
4
ABOUT BATTERIES
NOTE: The DSS requires four (4) new “AAA”
alkaline batteries (not supplied). Do not mix
old and new batteries or mix alkaline with
manganese-type batteries.
Installing Batteries
1. On the back of the remote control, push
the tab and lift the battery compartment
cover off.
2. Match the + and – marks on the batteries
to the + and – marks in the battery case
and insert four (4) “AAA”alkaline batteries.
3. Press the battery cover back into place.
The tab should click when the cover is
locked.
4. Test the unit by pressing POWER and any
Component key (e.g.,TV, VCR, CBL, etc.).
If the batteries are inserted correctly, the
red indicator light will blink once.
Battery Saver
The DSS has a Time-Out feature that will
automatically deactivate the remote control if
a key is depressed for more than 30 seconds.
This feature will help conserve the battery life
should your remote control get stuck in a
place where keys remain depressed (e.g.,
between the sofa cushions).
Replacement And Code Saver
When the batteries need replacing, the DSS
remote control will stop working and will
require four (4) new “AAA”alkaline batteries
for continued operation. Simply replace the
batteries,and the DSS remote control will be
restored to its full functionality, complete
with your favorite settings.
All of the codes and programmed informa-
tion will be stored,ensuring that you will not
have to reprogram the DSS remote control.
1
2
3
USING THE LIGHTED KEYPAD
When activated,the DSS remote control fea-
tures a lighted keypad that illuminates all of
the remote control keys whenever you press
any key.
1. To turn on the keypad back light,
press LIGHT once.The keypad will
remain lit for 5 seconds after you
release any key.
2. To turn off the keypad back light,
press LIGHT once again.(The key-
pad will not light whenever you
press any key.)
REM400 Manual Engl 12/28/99 12:01 PM Page 4