Filter
Top Products
SLOT1
1
2
1
2
1
2
SERIAL PC IN
AUDIO
SLOT2 SLOT3
VIDEO
AUDIO
R L
AUDIO
R L
AV IN B A
S VIDEO
8
Connections
SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
(Example: TH-42PH10EK)
AC cord connection
(see page 12)
Speakers (Optional accessories)
– Cable fi xing bands Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten: To loosen:
Pull
Pull
Push the catch
– AC cord fi xing
Notes:
•
On TH-42PH10EK/S, TH-50PH10EK/S and TH-58PH10EK, Terminal board is installed in SLOT 1 at factory shipment.
• On TH-42PS10EK/S, SLOT 1-3 are all empty at factory shipment.
Dual Video Terminals (equivalent
of BNC Dual Video Terminal Board
(TY-FB9BD)) (see page 11)
From EXTERNAL
monitor terminal on
Computer (see page 9)
From SERIAL Terminal
on Computer
(see page 10)
Optional Terminal
Board Insert Slot
(covered)
Note:
Make sure that the AC cord is locked
on both the left and right sides.
Plug the AC cord into the display unit.
Plug the AC cord until it clicks.
Unplug the AC cord
Unplug the AC cord
pressing the two
knobs.
Note:
When disconnecting the AC cord, be
absolutely sure to disconnect the AC
cord plug at the socket outlet fi rst.