Filter
Top Products
8
Programming with ’VIDEOPlus+’
All the information required for a programming is contained
encoded in the VIDEOPlus+ code.
1 Switch on the TV set.
2 Press the
TIMER k
button on the remote control.
3 Please enter the VIDEOPlus+ code (up to 9 digits) printed
in your TV guide next to the start time of a TV pro-
gramme.
If you make a mistake, clear with the
CLEAR (CL)
button.
VIDEOPLUS
53124----
ONCE
------------------------
D/WgSELECT CLEAR gCL
0-9 OK
4 If you want to programme at daily or weekly intervals,
press the
SELECT
button until ’D-DAILY’ (daily intervals)
or ’W-WEEKLY’ (weekly intervals) appears on the TV
screen. The ’daily intervals’ function can only be used for
recordings to be made from Mondays to Fridays inclu-
sive.
5 Confirm the entries with the
OK
button. The resultant
data appear on the TV screen.
Note: If you use VIDEOPlus+ for the first time for this TV
channel, the ’SELECT PROG’ line appears when you
confirm the VIDEOPlus+ code. Select and confirm the
programme number for the TV programme required.
* If you wish to set a later end time for a recording,
press the
P q
button at step 5. With each press on
the
P q
button you add 15 minutes to the time.
* If e.g.: ’20:00’ appears in the display, please set the
clock.
6 Finally, press the
OK
button. Programming is now
complete.
The data has been stored in a TIMER block.
7 Make sure that a cassette without erase protection has
been loaded. Switch to standby with the
STANDBY m
button.
A programmed recording will only function when the
video recorder is switched to standby with the
STANDBY m
button.
Note:
* VIDEOPlus+ Aerial-code numbers: With this video
recorder, VIDEOPlus+ aerial-code numbers will be al-
located automatically.
Programming recordings manually
1 Switch on the TV set. Press the
TIMER k
button twice.
2 Select a free TIMER block. Press the
TIMER k
button.
3 With the
TIMER k
button you can select between the
entries ’DATE’ (date), ’PROG’ (programme number),
’START’ (start time) and ’END’ (stop time).
You can enter or adjust data. Confirm each entry with the
TIMER k
button.
You can select between ’D’ (daily intervals) or ’W’
(weekly intervals) at step ’DATE’ with the
SELECT
button.
4 Finally, press the
OK
button. Programming has now
been completed.
5 Make sure that a cassette without erase protection has
been loaded. Switch to standby with the
STANDBY m
button.
Note:
* Clear a TIMER block: At step 1select the TIMER
block that you want to clear. Press the
CLEAR (CL)
button.
If e.g.: ’20:00’ appears in the display, the clock must be
set.