Filter
Top Products
&
Programming with ’VIDEOPlus+’
All the information required for a programming is contained encoded in the VIDEOPlus+ code.
1 Switch on the TV set.
2 Press the
TIMER k
button on the remote control.
3 Please enter the VIDEOPlus+ -code (up to 9 digits) printed in your TV guide next to the start time
of a TV programme.
If you make a mistake, clear with the
CLEAR (CL)
button.
4 If you want to programme at daily or weekly intervals, press the
SELECT
button until ’D-DAILY’
(daily intervals) or ’W-WEEKLY’ (weekly intervals) appears in the display. The ’daily intervals’
function can only be used for recordings to be made from Mondays to Fridays inclusive.
5 Confirm the entries with the
OK
button . The resultant data appears on the TV screen.
Note: If you use VIDEOPlus+ for the first time for this TV channel, the ’SELECT PROG’ line
appears when you confirm the VIDEOPlus+ code. Select and confirm the programme number
for this particular TV programme.
* If you wish to set a later end time for a recording, press the
P q
button at step 5. With
each press on the
P q
button you add 15 minutes to the time.
* If e.g.: ’20:00’ appears in the display, please set the clock.
6 Finally, press the
OK
button. Programming is now complete.
The data has been stored in a TIMER block.
7 Make sure that a cassette without erase protection has been loaded. Switch to standby with the
STANDBY m
button.
A programmed recording will only function when the video recorder is switched to standby with
the
STANDBY m
button.
How to programme a recording manually
1 Switch on the TV set. Press the
TIMER k
button twice.
2 Select a free TIMER block. Press the
TIMER k
button.
DATE PROG START END
01 01 20:00 21:30
------------------------
NEXT gTIMER CLEAR gCL
-/+ 0-9 D/WgSELECT OK
3
With the
TIMER k
button you choose between the entries ’DATE’ (date), ’PROG’ (programme
number), ’START’ (start time) and ’END’ (stop time).
You can enter or adjust data. Confirm each entry with the
TIMER k
button.
You can select between ’D’ (daily intervals) or ’W’ (weekly intervals) at step ’DATE’ with the
SELECT
button.
4 Finally, press the
OK
button. Programming has now been completed.
5 Make sure that a cassette without erase protection has been loaded. Switch to standby with
the
STANDBY m
button.
A programmed recording will only function when the video recorder is switched to standby
with the
STANDBY m
button.
Note:
* Clear a TIMER-block: At step
1select the TIMER block you want to clear. Press the
CLEAR (CL)
button.
* If e.g.: ’20:00’ appears in the display, the clock must be set.