Filter
Top Products
Reducing picture disturbance (’optimizing
the modulator’)
You may experience picture disturbance if you have not used
a scart cable to connect your video recorder and TV. This is
because another TV station in your reception area may
already be using UHF-channel CH36 or 591MHz.
a Make sure that there is no cassette in the video recorder.
With the video recorder switched off hold the SYSTEM
button for a few seconds until the modulator frequency,
for example, ’G591’ (591 Mhz or channel 36) appears on
the video recorder display. The video recorder will then
transmit a test picture channel or frequency.
MODULATOR 591 G
------------------------
-/+ G/KgSELECT
ON/OFF gCL OK
b Change the modulator frequency with the P r or
P q button.
c Confirm the new modulator frequency with the OK
button.
d Tune in the TV set to this channel or frequency.
e To end, press the TV/STANDBY m button.
DIf the picture or sound quality is poor, you may have
selected the wrong TV system. At step a , select
the TV system ’G591’ for PAL-B,G or ’K591’ for
SECAM-D,K, using the SELECT button. If you want to
switch the modulator on again, hold the
CLEAR (CL), y button, until ’G591’ (Modulator
switched on) appears on the display.
f To end, press the TV/STANDBYm button.
Switching off the modulator
If you cannot clear picture or sound interference, you can
switch off the built-in modulator.
You should only do this if you have connected the video
recorder to the TV set with a scart cable. ’Connecting VCR
without scart cable’ is not possible when the modulator is
switched off.
a Switch on the TV set and select the programme number
for the video recorder.
b Make sure that no cassette is in the video recorder.
Press the SYSTEM button for several seconds, until, for
example, ’G591’ appears on the video recorder display.
c Hold the CLEAR (CL), y button, until ’MOFF’ (modulator
off) appears on the video recorder display. If you want to
switch the modulator on again, hold the CLEAR(CL), y
button, until ’G591’ (Modulator switched on) appears on
the display.
d To end, press the TV/STANDBYm button.
21