Filter
Top Products
Reducing picture disturbance (’optimizing
the modulator’)
You may experience picture disturbance if you have not used
a scart cable to connect your video recorder and TV. This is
because another TV station in your reception area may
already be using UHF-channel CH36 or 591MHz.
a Make sure that there is no cassette in the video recorder.
With the video recorder switched off hold the SYSTEM
button for a few seconds until the modulator frequency,
for example, ’G591’ (591 Mhz or channel 36) appears on
the video recorder display. The video recorder will then
transmit a test picture channel or frequency.
MODULATOR 591 G
------------------------
-/+ G/KgSELECT
ON/OFF gCL OK
b Change the modulator frequency with the P r or
P q button.
c Confirm the new modulator frequency with the OK
button.
d Tune in the TV set to this channel or frequency.
e To end, press the TV/STANDBY m button.
DIf the picture or sound quality is poor, you may have
selected the wrong TV system. At step a , select
the TV system ’G591’ for PAL-B,G or ’K591’ for
SECAM-D,K, using the SELECT button. Press the
SYSTEM button for several seconds, until, for
example, ’G591’ appears on the video recorder
display. If you want to switch the modulator on
again, hold the CLEAR(CL), y button, until ’G591’
(Modulator switched on) appears on the display.
f To end, press the TV/STANDBYm button.
Switching off the modulator
If you cannot clear picture or sound interference, you can
switch off the built-in modulator.
You should only do this if you have connected the video
recorder to the TV set with a scart cable. ’Connecting VCR
without scart cable’ is not possible when the modulator is
switched off.
a Switch on the TV set and select the programme number
for the video recorder.
b Make sure that no cassette is in the video recorder.
Press the SYSTEM button for several seconds, until, for
example, ’G591’ appears on the video recorder display.
c Hold the CLEAR (CL), y button, until ’MOFF’ (modulator
off) appears on the video recorder display. If you want to
switch the modulator on again, hold the CLEAR(CL), y
button, until ’G591’ (Modulator switched on) appears on
the display.
d To end, press the TV/STANDBYm button.
21