Filter
Top Products
COPYING TAPE MANAGER MEMORY ENGLISH
24
24
CCooppyyiinngg TTaappee MMaannaaggeerr mmeemmoorryy
If you no longer wish to use a video recorder (henceforth
referred to as VCR A), but would still like to use your Tape
Manager archive, you can transfer the content of the memory to
a second video recorder (henceforth referred to as VCR B).
Requirement: 1. VCR B must also be equipped with a Tape
Manager System, 2. The memory of the Tape Manager of VCR B
must be empty.
1 Make sure there are no cassettes in either of
the two video recorders and switch VCR A and
VCR B off using the Standby button
mm
2 Take a scart cable and connect the scart socket
AAVV11 EEXXTT11
on the back of VCR A with the scart
socket
AAVV11 EEXXTT11
on the back of VCR B
3 On the front of VCR A, press simultaneously
the Record button
RREECCOORRDD
n and the
button
PPRROOGGRRAAMMMMEE --
4 On the front of VCR B press simultaneously
the Playback button
PPLLAAYY
G and the button
PPRROOGGRRAAMMMMEE --
5 The data in the Tape Manager will be copied
from VCR A to VCR B. This may take several
minutes.As soon as the copying procedure has
been completed, the display will show the
message OK
88
NO E
aappppeeaarrss iinn tthhee ddiissppllaayy ooff VVCCRR BB
44
Cassettes had already been included in the Tape
Manager of VCR B. It is not possible to perform
the copying procedure. Press the Standby button
mm
to finish this function
88
NO D
aappppeeaarrss iinn tthhee ddiissppllaayy ooff VVCCRR BB
44
There are no cassettes included in the Tape
Manager of VCR A. Press the Standby button
mm
to
finish this function
88
ERR
aappppeeaarrss iinn tthhee ddiissppllaayy ooff VVCCRR BB
44
The copying procedure cannot be performed.
Perform steps 1 to 5 again
PPRROOBBLLEEMM
6 Both video recorders switch off automaticall-
ly. The data in the Tape Manager have been
successfully transferred. Disconnect the scart
cable
h
--
PROGRAMME
VCR A
VCR B
VCR A
G
--
PROGRAMME
VCR B
AV1 EXT1