Filter
Top Products
OPTIMIZING THE MODULATOR ENGLISH
58
58
OOppttiimmiizziinngg tthhee mmoodduullaattoorr
If the TV set and the video recorder are only connected with an
aerial cable - rather than with an additional scart cable - it may
happen that in certain reception locations the modulator
frequency of the video recorder is occupied by a TV channel. As
soon as the video recorder is switched on, the reception quality
of the TV picture deteriorates.The following steps will show you
how to overcome this problem.
SSuupppprreessssiinngg iinntteerrffeerreennccee
12
12
TTIIPP
WWhhaatt iiss aa mmoodduullaattoorr??
The purpose of this electronic assembly inside your
video recorder is to pass on the picture and sound
information read in from the video tape via an aerial
cable like a TV signal to the TV set. The modulator
frequency determines the frequency range in which
these signals are transmitted.
1 Switch the video recorder on and make sure
there is no cassette in the video recorder
3 The display shows MON. The video
recorder will now transmit a test image on
this frequency
2 Press simultaneously the
EEJJEECCTT
button
JJ
on
the front of the video recorder and the
button
PPRROOGGRRAAMMMMEE --
until the display
shows the modulator frequency (e.g.M583
or CH35 ).
4 Use
==PP--
or
;;PP++
to select the option
OPTIMIZE and enter a new frequency
with the number buttons
00--99
PPRROOBBLLEEMM
WWhhiicchh mmoodduullaattoorr ffrreeqquueennccyy sshhoouulldd II eenntteerr??
You can also make the video recorder search
automatically for an appropriate frequency. To do so,
simply hold down the button
PP
. As soon as a free
frequency has been found,it will be shown in the display.
5 Tune the programme number of your TV set
allocated for video use to the new modulator
frequency until you see the test image
sharply and in colour
M583
OPTIMIZE MODULATOR
OPTIMIZE
Q583P
MODULATOR ON
CHANNEL/FREQ. FREQ
TO EXIT
PRESS MENU
-
J