Filter
Top Products
09
46
En
Picture disturbance during
playback or the picture is
dark.
• This player is compatible with Macro-Vision System copy guard.
Some discs include a copy prevention signal, and when this type of
disc is played back, stripes etc., may appear on some sections of
the picture depending on the TV. This is not a malfunction.
• Due to the player’s copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.
• Check whether the TV system is properly set (page 44).
No audio, or audio is
distorted.
• No audio is output during slow motion playback or when
scanning discs other than audio CDs.
• Some DVD discs do not output digital audio: Switch your
amplifier to the player’s analog outputs.
• Check that the disc is free from dust and dirt, and that it is not
damaged (page 42).
• Check that all interconnects are firmly inserted.
• Check that the plugs and terminals are free of dirt, oxide, etc. and
clean if necessary. Also check the cable for damage.
• Make sure the player’s output is not connected to the amplifier’s
phono (turntable) inputs.
• Check your amplifier/receiver’s settings (volume, input function,
speaker settings, etc.).
The analog audio is OK, but
there appears to be no
digital audio signal.
• Make sure that the Digital Out setting is set to On (page 35).
• Check that the Dolby Digital Out, DTS Out and MPEG Out
settings (page 35) are suitable for your amplifier/receiver — check
the instruction manual that came with your amplifier/receiver.
Noticeable difference in DVD
and CD volume.
• This is due to differences in the audio format and is not a
malfunction.
Cannot play multi-channel
audio.
• Check that the Dolby Digital Out, DTS Out and MPEG Out
settings (page 36) are suitable for your amplifier/receiver — check
the instruction manual that came with your amplifier/receiver.
• Check the audio options available from the disc menu.
Cannot listen to
high-sampling rate audio
through the digital output.
• Make sure that 96kHz PCM Out is set to 96kHz (page 36).
• As a copy-protection measure, some DVDs do not output 96 kHz
audio. In this case, even if set to 96kHz, the player automatically
outputs the audio at 48 kHz. This is not a malfunction.
Cannot output 96 kHz or
88.2 kHz digital audio.
• Check that 96kHz PCM Out is set to 96kHz (page 36).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
No DTS audio output. • If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set DTS Out to DTS > PCM/Off
(page 36). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that
the cable is properly connected.
The audio recorded on a
Super VCD disc is not output
properly.
•
If the audio is switched to [2] when playing a Super VCD that
contains only one stereo soundtrack, there may be no sound at all.
Press AUDIO to change the soundtrack.
Problem Remedy
DV510K_IBD_EN.book 46 ページ ２００８年３月２８日 金曜日 午前１１時５４分