Filter
Top Products
28
En
Using the Setup Screen
Menus
The procedure on this page describes how to operate the
menus on the Setup screen. These menus are used to
set and adjust a number of system settings. The various
functions that can be adjusted are covered throughout
this manual. The procedure on this page provides a basic
outline for using the Setup screen menus.
When setting up for the first time
It is recommended to set up player using the Setup
Navigator (page 20). If you selected [Auto Start Off]
when the Setup Navigator appeared, you may still set up
the player using the Setup Navigator in the General menu
screen.
If you choose not to use the Setup Navigator, be sure to
make the necessary settings in the Setup screen
Audio 1, Audio 2, Video, and Language menus as
described on the following pages.
Some DVDs start playing automatically when loaded in
the player. If a DVD has been loaded, be sure to press
STOP 7 before proceeding.
Procedures in this section use the DV-S88A.
Differences in procedures of other models are clearly
marked by white numbered steps.
2 Press SETUP.
The Setup screen appears.
3 Move the cursor control joystick right or
left to select the menu you want.
As each menu is selected with the cursor, the
settings appear below the menu heading.
4 Move the cursor control joystick down to
enter the menu.
The top item within the menu becomes highlighted.
5 Move the cursor control joystick up or
down to select the setting you want to
change.
The options available for each setting appear to the
right when the setting is selected. The current
setting appears with the setting indicator lit.
6 Move the cursor control joystick right to
enter the setting options.
• Not all menu options can be changed while a disc
is playing. In these cases, the options appear
grayed out on the screen and cannot be adjusted.
To change these settings, press STOP 7 first
before pressing SETUP.
• Operating the menu after pressing STOP 7 may
cancel the resume function.
• Some menu options are not immediately
effective if set while a disc is playing. To make
these settings effective, stop playback and then
start again, or change the settings while the disc
is stopped.
(Example)
(Example)
Audio1 Audio2 GeneralLanguageVideo
Dolby Digital Out
DTS Out -
Linear PCM Out – Down Sample On
MPEG Ou
t – MPEG 3 PCM
Move
Exit
Dolby Digital 3 PCM
Dolby Digital
SETUP
Select
ENTER
Digital Out – On
(Example)
Adjusting Audio
and Video
Settings
Audio1 Audio2 GeneralLanguageVideo
Dolby Digital Out – Dolby Digital
Digital Out – On
DTS Out – Off
Linear PCM Out – Down Sample On
MPEG Ou
t – MPEG 3 PCM
SETUP
Move
Exit
continued
SEARCH MODESTEP / SLOWRETURN
PREVIOUS NEXT REV FWD
PAUSEPLAY
VIDEO
ADJUST
DIMMER JOG MODE
TOP MENUSET UP
DISPLAY AUDIO SUBTITLE ANGLE
OPEN /
CLOSE
FUNCTION
MEMORY
STOP
C321
CLEAR
MENU
ENTER
V.ADJ
FL
F.MEM
JOG
873
4¢ 1
eE
¡
AUDIO
/
VIDEO
1
2
3, 4, 5, 6
1(1)
Audio1 Audio2 GeneralLanguageVideo
DTS Out -
Linear PCM Out – Down Sample On
MPEG Ou
t – MPEG 3 PCM
Move
Exit
Dolby Digital 3 PCM
Dolby Digital
SETUP
Dolby Digital Out
Digital Out – On
1 Press STANDBY/ON on the front panel
(
on the remote control). (DV-S88A)
1 Press POWER on the front panel. (DV-
S838A)