Filter
Top Products
Preparation 05
19
En
English
Note
• Disconnect the power cord from the power outlet when the plasma
television is not going to be used for a long period of time.
Connecting the power cord
Preparing the remote control unit
Inserting batteries
1 Open the battery cover.
2 Load the supplied two AA size batteries while inserting their
respective negative polarity (–) ends first.
Place batteries with their terminals corresponding to the (+) and (–)
indicators in the battery compartment.
3 Close the battery cover.
Caution
Improper use of batteries can result in chemical leakage or an
explosion. Be sure to follow the instructions below.
• When you replace the batteries, use manganese or alkaline ones.
• Place the batteries with their terminals corresponding to the (+)
and (–) indicators.
• Do not mix batteries of different types. Different types of batteries
have different characteristics.
• Do not mix old and new batteries. Mixing old and new batteries can
shorten the life of new batteries or cause chemical leakage in old
batteries.
• Remove batteries as soon as they have worn out. Chemicals that
leak from batteries can cause a rash. If you find any chemical
leakage, wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter life
expectancy due to storage conditions.
• If you will not use the remote control unit for an extended period of
time, remove the batteries from it.
• WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY
WITH GOVERNMENTAL REGULATIONS OR ENVIRONMENTAL
PUBLIC INSTITUTION’S RULES THAT APPLY IN YOUR
COUNTRY/AREA.
Operating range of the remote control unit
Operate the remote control unit while pointing it toward the remote
control sensor (t) located at the bottom right of the front panel of the
plasma television. The distance from the remote control sensor must
be within 7 m and the angle relative to the sensor must be within 30
degrees in the right, left, upward, or downward direction.
Europe, except UK and
Republic of Ireland
UK and Republic of Ireland
Power cord
Rear view
30 º
30 º
Remote
control
sensor
7 m