Filter
Top Products
07 Preparation
22
En
Using the remote control unit
Use the remote control unit by pointing it towards the
remote sensor window. Objects between the remote
control unit and sensor window may prevent proper
operation.
Cautions regarding the remote control
unit
• Do not expose the remote control unit to shock. In
addition, do not expose the remote control unit to
liquids, and do not place in an area with high humid-
ity.
• Do not install or place the remote control unit under
direct sunlight. The heat may cause deformation of
the unit.
• The remote control unit may not work properly if the
remote sensor window of the Plasma Display is under
direct sunlight or strong lighting. In such case,
change the angle of the lighting or Plasma Display
set, or operate the remote control unit closer to the
remote sensor window.
Inserting batteries
If the remote control unit fails to operate Plasma
Display System functions, replace the batteries in the
remote control unit.
1
Open the battery cover.
2
Insert the two AA size batteries supplied with the
product.
•Place batteries with their terminals corresponding
to the (+) and (–) indicators in the battery compart-
ment.
3
Close the battery cover.
PDP-ELITE-Eng (17-27) 9/9/03, 11:4422