Pioneer VSX-D811S TV Cables User Manual


 
Controlling the rest of your system
09
51
En
4 Point the two remote controls towards
each other about 1-2 inches apart then
press the button that will be doing the
learning on this receivers remote control
(for example 3, 7, etc.).
The LED flashes rapidly.
1 - 2 inches
TV
TVFUNC
MENU
VOLUME
MASTER VOLUME
TV CONTROL
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
CHANNEL
ENTER
ENTER
DISC
DTV INFO
MPX/RETURN
DTV ON/OFFDTV MENU
D.ACCESSGUIDE
ST
TUNE
TUNE
ST
CLASS
ATT
BAND
/DTS DSP
TEST TONE
CH SELECT CH LEVEL FUNCTION
SIGNAL SELECT
4
¢
7
8
3
EFFECT
DVD VCR CD-RTV
RCV
TUN
TVC
CD
MIDNIGHT
LOUDNESS
MUTING
SETUP
FL DIMMER
MULTI CONTROL
5.1 / 7.1
RECEIVER
SOURCE
1
2
3
4
5
6
7
8
9
0
10
2
5 Press the corresponding button on the
other remote control that is sending
(teaching) the signal to this receivers
remote control (for example 3, 7, etc.).
If the operation has been learned successfully,
the LED on this receivers remote will go out
and then light steadily.
If for some reason the operation hasnt been
learned the LED will blink for three seconds and
then light steadily. If this happens, keep
pressing the (teaching) button as you vary the
distance between the two remotes, until you
see the the LED light steadily.
To program additional operations for the current
component repeat steps 4 and 5.
To program operations for another component
exit and repeat steps 1 through 5.
6 Press and hold the REMOTE SETUP
button for three seconds to store the
operation(s).
Some commands from other remote
controls cannot be learned, but in most
cases the remotes just need to be moved
closer together or farther apart.
Certain buttons represent operations that
cannot be learned from other remote
controls. These include: RECEIVER ,
REMOTE SETUP and the MULTI
CONTROL, RECEIVER CONTROL and
MASTER VOLUME buttons.
TV CONTROL buttons (TV , TV VOL +/-,
and TV INPUT) can only be learned after
selecting TV or TVC.
Erasing one of the remote
control button settings
(VSX-D811S only)
This erases one of the buttons you have
programmed and restores the button to the
factory default.
1 Press REMOTE SETUP and hold for three
seconds.
The LED lights steadily for two seconds.
2 Press the MULTI CONTROL button
relating to the button setting to be erased.
3 Prepare the remote to erase the button
setting.
Press the RECEIVER button twice quickly.
The LED blinks to indicate the remote is ready
to erase the button setting.
4 Press and hold the button to be erased
for three seconds.
The LED lights steadily for three seconds and
then goes off.
5 Repeat step 4 to erase other buttons.
6 Press and hold the REMOTE SETUP
button for two seconds to exit.
Clearing all the remote
control settings
You can clear all presets and restore the factory
default settings.
1 Press REMOTE SETUP and hold for three
seconds.
The LED lights steadily for two seconds.
XRB3013A.49.67 01.12.12, 4:49 PM51