Filter
Top Products
15 Reserved
16 F1 Same as F1 key of front panel.
17 Lens control
IRIS, FOCUS ZOOM for lens
control.
18 F2 Same as F2 key of front panel.
Loading the batteries into the IR controller
1. Remove the battery cover.
2. Insert the battery. Please take care that the poles (+ and -) are correctly positioned.
3. Replace the battery cover.
Start to use IR controller
Press DEV key, input the DVR device ID (default is “88”, can be changed in “Display”
menu) and then press ENTER key. If the “STATUS” lamp of DVR front panel is turned into
green, it means you can use IR controller to operate this DVR.
Stop using IR controller
When IR controller status is on, press DEV key again, the “STATUS” lamp will be turned
off. The IR controller can not control this DVR.
Switch the DVR off
When IR controller status is on, press POWER key for several seconds, the DVR will be
powered off.
When IR controller can not work normally
z Check batteries poles.
z Check the remaining charge in the batteries.
z Check IR controller sensor is mask.
Please change another IR controller to try again. It the problem is still existed, please
contact administrator.
Page 14