Filter
Top Products
5
Remote Control
1. POWER
2.
NUMBER BUTTONS
3. SHUFFLE
4. PROGRAM
5. KODAK T.E.
6. RESUME
7. SLOW
8. STEP
9. SETUP
10. AUDIO
11. MENU
12. DIRECTION BUTTONS
13. ENTER/PLAY
14. PAUSE
15. SKIP FORWARD/ REVERSE
16. OPEN/CLOSE
17. VOLUME UP / DOWN
18. REPEAT
19. A-B REPEAT
20. MUTE
21. GOTO
22. CLEAR
23. DISPLAY
24. I/P(INTERLACE/PROGRESSIVE SCAN)
25. ZOOM
26. PAL/NTSC
27. ANGLE
28. SUBTITLE
29. TITLE
30. STOP
31. FAST FORWARD
32. FAST REVERSE
THE INSTRUCTIONS BELOW DESCRIBE THE FUNCTIONS ON THE REMOTE CONTROL.
6
4
13
2
23
31
26
29
27
22
16
20
18
7
14
12
17
30
15
NOTICE:
• POWER button on the remote control is for standby power only. Turn on the main power
button on the DVD Video Player.
• P/N button is for PAL/NTSC. If a PAL region 1 DVD disc is played, when the player is stopped
completely, press P/N for normal playback. Otherwise, the picture will continuously roll.
• MUTE button cuts out sound from the player; MENU returns the player to the movie menu at
the beginning of a disc; VOL controls player volume.
• When “ ” displayed on TV, function is not operational on the disc.
24
3
5
8
9
10
11
21
25
28
1
19
32
To operate the DVD video player, you must first place the
batteries in the remote control.
1.Open the cover.
2.Insert batteries (AA size).
Make sure to match the + and - on the batteries to the marks
inside the battery compartment.
3.Close the cover.
BATTERIES
INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK, CORRODE OR
EXPLODE.
• Do not place the batteries in the wrong direction.
• It is dangerous to charge/heat/open or short-circuit the batteries.
• Do not leave dead batteries or mix old/new batteries in the remote
control.
• When not using the remote control for a long duration of time,
remove the batteries.When operating range becomes reduced,
replace batteries.
• If battery leakage occurs, wipe the battery liquid from the battery
compartment, then replace batteries.
REMOTE CONTROL
• The remote control should be aimed directly towards the remote
sensor of the DVD video player.
The remote control must point at the remote sensor in order for the player to
function correctly.
Distance: Maximum of 7 m from the front of the remote sensor.
Angle: Approximately 30° from each direction.
*Do not place the remote sensor towards any light source such as direct sunlight. The DVD
video player may malfunction.
30
30
OPERATING WITH THE REMOTE CONTROL
Operating video player with the remote control.