Filter
Top Products
Instruction Manual
6
INSTALLATION
- Please read the safety instructions in this manual completely before installation.
- Install your TV in an area where direct sunlight will not fall upon the screen.
- Soft, indirect light is best for television viewing.
- Allow enough space (at least 4 in.) between the TV and any walls or enclosures for proper ventilation.
- Optimum television viewing distance is 3-5 times the screen's size.
Auto-Degaussing
Color television can be easily affected by magnetism, which shows as color distortion on the screen. If your TV is affected by
nearby magnetic components or appliances, turn it off for a few minutes. The built-in auto-degaussing circuit will eliminate the
magnetic interference.
Auto off when no signal received
The TV set will automatically enter into Standby mode when the following conditions are met.
1.TV is in antenna mode.
2.Current channel has no signal.
3.No key is pressed within 15 minutes.
Connecting the Antennae
Notes :
1. It is recommended that a 75 ohm coaxial cable be used in order to eliminate interference and noise which may occur due
to nearby radio transmissions.
2. The antenna cable should not be tied together with other wiring.
3. Set up a lightning rod and check it regularly when an outdoor antenna is used.
Installing the Remote Control Batteries
1. Remove the battery compartment lid.
2. Insert two AAA batteries (included). Make sure the positive (+) and negative (-) polarities are correctly aligned.
3. Reattach the battery lid.
Notes:
1. Alkaline batteries are recommended for longer life.
2. Always replace both batteries at the same time.
3. Do not expose batteries to fire or break them open.
4. To avoid battery leakage, remove batteries from the remote control when it is not being used for a long period of time.
VHF
UHF
or Cable
VHF
UHF
75-ohm coaxial cable
(
not su
pp
lied
)
300-ohm twin-lead cable (not supplied)
A
ntenna adapter
(not supplied)
U/V mixer
(not supplied)
RF Input
(
back of TV unit
)