Filter
Top Products
17
Troubleshooting
If you have any problem, check the countermeasures for each symptom listed below.
The following symptoms may have been caused by inappropriate adjustments rather
than actual malfunction of the unit.
If the trouble persists, contact the service center.
SYMPTOMS POSSIBLE SOLUTIONS
TV does not operate
Poor sound or no sound
Poor picture or no picture
Poor reception on some
channels
Poor color or no color
Make sure the power cord is plugged in.
Try another AC outlet.
Power is off ; check fuse or circuit breaker.
Station or CATV experiencing problems; tune to another sta-
tion.
Check sound adjustments (Volume and Mute).
Check for source of possible interference.
Station or CATV experiencing problems; tune to another sta-
tion.
Check antenna or CATV connections; reorient antenna.
Check for source of possible interference.
Check picture adjustments.
Station or CATV experiencing problems; tune to another sta-
tion.
Station signal is weak; reorient antenna to receive weaker
station.
Check for sources of possible interference.
Station or CATV experiencing problems; tune to another sta-
tion.
Check picture adjustments.
Make sure Antenna Mode is correct.
Check antenna or CATV connections; reorient antenna.
Check for sources of possible interference.
Picture wobbles or drifts
Station or CATV experiencing problems; tune to another sta-
tion.
CATV company is scrambling signal.
Check antenna orientation.
No CATV reception
Check CATVconnections.
Make sure Antenna Mode is correct.
Station or CATV system problems; try another station.
Horizontal or diagonal bars
on screen
Check antenna connections and reorient antenna.
Make sure Antenna Mode is correct.
Check for source of possible interference.
No remote operation
Batteries are weak, dead or inserted improperly.
Remote is out of range; move closer to TV.
Make sure remote is aimed at sensor.
Confirm no obstructions between remote and TV.
Make sure power cord is plugged in.
TV shuts off
Sleep Timer is set.
Power interrupted.
No reception above
channel 13
Make sure Antenna Mode is correct.
If using UHF antenna, check connections.