Filter
Top Products
12
EN
Setting the RF out channel
In some reception locations it is possible that a
TV channel will be sent on the same or similar
frequency as the video recorder.
Result: As soon as the video recorder is
switched on, the reception quality for this or sev-
eral other TV channels will decrease.
The following steps will show you how to change
the pre-set 'transmission' (RF out channel) fre-
quency on the video recorder.
1.
1.Switch on the TV. If required, select the pro-
gramme number for the video recorder.
2.
2.Press . The main menu will appear.
3.
3.Select 'INITIAL SET UP' with and
confirm with .
4.
4.Select 'RF OUT' with and confirm
with .
5.
5.Press .
6.
6.Press
or to select the channel
which is not broadcasted between channel 22
and channled 69 in your area.
7.
7.Press
. When you want to receive TV
signals directly from the VHF/UHF TV aerial,
select the channel 22 first
. Then, press
and confirm with .
8.
8.To end, press .
STATUS/EXIT
B1
LC
B1
0..9
LCKB
B1
B1
LCKB
B1
LCKB
MENU
SELECT KL CHOOSE B
→RF OUT CH 35
END=EXIT
What is RF out channel?
This electronic component in the video recorder
allows the device to transmit audio and video
signals via the aerial cable. These signals can
be received on a TV set just like TV channels.
This frequency or channel indicates the channel
on which the audio or video signal is transmit-
ted.
VR630/07 02.2.6 10:13 AM Page 12