Filter
Top Products
CTM-MS2
Page - 6 - Installation Manual
Finding the Center of the Plasma Display
Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure
to do so could result in serious personal injury and possible damage to the flat panel.
Invert the flat panel place it on a soft, flat surface to prevent damage to the flat panel. Use a blanket, foam, etc. Failure to
do so will result in damaging the flat panel. Do not lay the flat panel on the floor without any protection to the glass. The
flat panel is heavy and fragile. At least (2) qualified personnel are strongly recommended for installation of this product.
Failure to do so could result in serious injury and possible damage to the flat panel.
Tape
Measure
Inverted
FlatPanel
Bottom of
Flat Panel
C
L
Topof
Flat Panel
Inverted
FlatPanel
MarkingtheCenter
oftheFlatPanel
L
C
Step 1. Once the flat panel is inverted, use a measuring tape to
find the center of your flat panel measuring from outside
to outside of the chassis.
Step 2. Use a pencil to lightly mark the center of your flat
panel.
Positioning the Mounting Brackets
If your display has uneven mounting points, or recessed mounting points, please use the provided
universal spacers.
Universal Spacers Installation
Center Mark
Inverted
Flat Panel
Universal Spacers
The universal spacer may be stacked five (5) high, for a
total stacking height of 1-1/4”. The universal spacers must
be stacked in the direction shown above. The universal
spacers must be placed between the mounting bracket and
the flat-panel. The universal spacer can fit M4, M5, M6
and M8 screws sizes.
Step 1. Place the universal spacers over the mounting points on the
flat panel.