Filter
Top Products
CTM-MS2
Installation Manual Page - 9 -
Securing the Plasma to the Wall Mount
IT IS STRONGLY RECOMMENDED THAT 2 QUALIFIED PERSONS COMPLETE THE INSTALLATION OF THIS
PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE
FLAT PANEL.
Step 1. Raise the flat panel with the mounting
brackets secured to the flat panel and
insert the top and bottom hooks from each
bracket to the rods from the wall plates.
Do not over tighten the M6 screws to the rods.
Lateral Shift Adjustment
Step 1. Locate the two (2) mounting holes that are on the
bottom of each mounting bracket arm.
Step 2. Insert and tighten two (2) M6 x 30mm lateral shift
locking screws.
Step 3. Make any lateral shift adjustments at this time.
Once the desired position has been determined,
use a Phillips tip screwdriver and tighten the two
lateral shift locking screws.
Although not depicted in the illustrations shown above, the width of this wall mount will encompass two wall
studs.