Filter
Top Products
PWM-F110
Page - 15 - Installation Manual
2. Make any lateral shift adjustment and lock it by tightening the two (2) ¼”-20 Phillips screws found on
the bottom of the mounting brackets. Use the wall bumper to adjust your flat panel.
CAUTION: Do not over tighten the ¼”-20 screws to the rods (Figure 16).
NOTE
: To remove the flat panel from the wall, simply back off the ¼”-20 screws using a Phillips
screwdriver and lift the unit of the wall carefully.
Figure 16
W
all Plate
W
all
Bum
p
er