Filter
Top Products
87
OPERATION OF REMOTE CONTROL:
Note:
Before use this remote control, please make sure
turn on the device by pressing the power button on
the front control panel.
1. Power On/Off.
2. Mute Button
3.
4. Level/MENU UP Button
5. SEL/MENU
Loudness Button
Button
6. Level/MENU Down Button
7. MO/ST Button 8. A.P Button
9.Band Button 10. Mode Button
11.Tune/Seek Up And Track Skip Up/FF Button
12.Tune/Seek Down And Track Skip Down/REW Button
13. SCAN BUTTON
Press the SCN button to scan the radio frequency. If a valid signal has
detected, the current frequency will be hold and blinked for 5 seconds,
then press SCN again to stop scan and remain the current frequency;
otherwise, the radio will go on to scan the other radio frequency fiver
seconds later.
14. Clock Display /Setting Button
15. LO/DX Button
In radio mode, press it to change local reception or distance reception.
And the LOC will showing on the LCD display when the receiver detect
some signal of stable local station.
Note: This operation is only for FM reception. During AM mode, LOC is void.
16. CD Track TOP/ /Radio Preset 1 17. CD Track INT/Radio Preset 2
18. CD Track RPT/Radio Preset 3 19. CD Track RDM/Radio Preset 4
20. Radio Preset 5 21. Radio Preset 6
REPLACE THE BATTERY OF REMOTE CONTROL:
1.Remove the battery holder as the direction indicated by the arrow.
2.Replace the battery, Set a new battery properly with (+) side up.
3.Insert the battery holder. Push in the holder to the original position.
BATTERY INFORMATION:
Designated Battery: CR2025 3V
Battery Life: 6 months with normal use in normal room temperature, and
the out of date battery must be immediately removed and disposed properly.
CAUTION:
Improper use of batteries may cause overheating, explosion or ignition, and
resulting in jury or fire .
Battery leakage may cause damage to the unit.
Do not disassemble or short the batteries.
Do not throw the batteries into the fire.
To avoid the risk of accident, keep the batteries out of reach of children.
The Maintenance of Remote Control