PYLE Audio PLTVATSC1 TV Receiver User Manual


 
Replacing the Remote Control Battery
7
1)Always use new battery when replace the old set.
2)Do not attempt to charge, short-circuit, disassemble,
heat or burn used batteries, battery may be explode
if mistreated.
3)Battery replacement is necessary when remote
control acts sporadically or stops operating.
4)Do not drop, apply shock or step on the remote control.
5)Do not spill water on the remote control.
6)Do not place objects between the remote control and remote sensor.
7)Do not use remote control for the other equipments at the same time.
8)Do not leave the remote near any heat sources, or in a place subject to direct sunlight
(especially on the dashboard).
9) Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately
consult a doctor.
10)If the REMOTE does not operate even when you operate the remote control from a close range,
it is time to replace the battery (use CR-2025 lithium battery), refer ring to the label on the back of
the basic control. Use any of other may be a risk of fire or explosion.
11)Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur.
12)Wipe the battery with dry cloth to assure a good contact.
13)Under normal conditions, batteries will last approximately 1 year. The service life may be shorter,
depending on the conditions of use.
+ side facing up
1
2
While pushing the
lock lever (1), pull
out the battery
holder (2)
Push to close
Remote control
x 1
Screw x 4
Ø3 x 15 mm
Accessories Included
Audio / Video Cable
x 1 (1.2m)
Power Supply
Wire x 1 (0.5m)
DTV Antenna
x 1 (5m)
Remote Sensor
x 1 (4.5m)
V
O
L
+
SOURC E
V
O
L
-
2. Installation