Filter
Top Products
Need help? Call
1-800-950-7044!
7
SETTING UP THE SYSTEM
INSTALLING BATTERIES IN THE
REMOTE CONTROL
Your system’s remote control uses four AAA batteries
(not supplied) for power. We recommend alkaline bat-
teries, such as Radio Shack Cat. No. 23-555. Follow
these steps to install the batteries.
1. Press the battery compartment cover tab and lift
off the cover.
2. Install four fresh batteries, as indicated by the
polarity symbols marked in the compartment.
3. Replace the cover.
Notes:
• Do not place objects on top of the remote control
after you install the batteries. This can press down
keys and reduce battery life.
• When the remote control’s range decreases or it
operates erratically, replace the batteries.
• Be sure to have fresh batteries ready to install
before you remove the old batteries. The remote
control’s memory only lasts about a minute with-
out the batteries. If the memory is lost, you must
re-enter the 3-digit manufacturer’s codes for your
remote-controlled devices.
SETTING UP THE REMOTE
CONTROL
1. Refer to “Manufacturers’ Codes” and write down
the codes for your remote-controlled devices on
the provided label.
2. Press the device key for the remote control you
are replacing (
CD
,
VCR
,
CBL
,
TV
,
AUX1
, or
AUX 2
).
AUX 1
VCR
AUX 2
CBL
A/B
Plug'n
Power
1 2
All
Lts On
SETUP
CD
3
CH
On
PWR
TV
15-1919.fm Page 7 Monday, July 19, 1999 12:34 PM