Filter
Top Products
CHAPTER 2: INSTALLATION 9
Initial Configuration
During initial configuration, the USTIP Setup Wizard helps you quickly set up USTIP for the
first time. The USTIP Setup Wizard appears only when accessing the Administrative Menus on a
non-configured USTIP, and guides you through initial configuration parameters. The easiest way
to perform this initial configuration is by using the Local Admin Console (see ‘Physical
Connection’ instructions in the previous sections).
1. Power ON USTIP via the power switch on the back of the USTIP unit.
2. The Welcome to USTIP Setup Wizard Screen will appear on the Local Admin Console.
Figure 6 USTIP Wizard Screen
3. Press the letter B on the Local Admin Console keyboard to begin the USTIP Setup Wizard.
4. The Network Configuration Screen appears.
Figure 7 USTIP Network Configuration Screen
5. Use the Tab, Ç or È keys to select each line on the Network Configuration screen and the
space bar, or the Å or Æ keys to toggle between available entries. Press the Enter, Tab or
È keys when your entry on each line is complete. Below are descriptions of each field, and
the appropriate values to assign.
• Name: Designate a unique name for this USTIP unit, for example, “MiamiDataCenter.”
Please note that this name should contain only alphanumeric characters, no spaces or symbols
permitted. The default name is USTIP.
• Enable Ethernet Interface: Designates whether USTIP should enable its Ethernet adapter as
active (default: YES).