Filter
Top Products
Connections & Setup
6 Chapter 1
Graphics contained within this publication are for representation only.
Connections & Setup
Chapter 1 7
Graphics contained within this publication are for representation only.
TV + HDTV Tuner + VCR + DVD Player
1. Make sure cable or antenna and/or satellite is connected to your VCR.
A. Connect the coaxial cable from your cable outlet or antenna to the antenna input on the HDTV Tuner.
B. Connect the satellite dish antenna to the satellite input on the HDTV Tuner.
2. Make the video connection between your HDTV Tuner and the TV.
A. Best Connection: DVI-HDTV
Connect a DVI-HDTV cable to the DVI-HDTV jack on the back of your HDTV Tuner. Connect the other end of the
cable to the DVI-HDTV input on the back of TV.
– OR –
B. Very Good Connection: Connect three video grade cables to the CMP1 Y PB PR jacks on the back of the TV and to
the Y PB PR jacks on the HDTV Tuner.
Notes: The DVI-HDTV and Y PB PR jacks send the digital cable signal to the TV in digital and analog formats,
respectively.
3. Make the audio connection between your HDTV Tuner and the TV (to match your video connection).
A. If you used the DVI-HDTV jack:
Connect the audio (white and red) cables to the DVI-HDTV L and R audio jacks on the back of the TV and to the
Audio Output jacks on the HDTV Tuner.
– OR –
B. If you used the Component Video jacks:
Connect the audio (white and red) cables to the CMP1 L and R audio jacks on the back of the TV and to the Audio
Output jacks on the HDTV Tuner.
4. Connect your HDTV Tuner to your VCR.
A. Connect a coaxial cable to the HDTV Tuner’s antenna output and to VCR’s antenna input.
B. Connect the audio (white and red) cables to the Audio Output jacks on the HDTV Tuner and to the Audio Input
jacks on the VCR.
C. Connect the video cable to the Video Output jack on the HDTV Tuner and to the Video Input jack on the VCR.
5. Connect your VCR to your TV.
A. Connect a coaxial cable to the VCR’s antenna output and to the ANTENNA/CABLE Input jack on the TV.
B. Connect the audio (white and red) cables to the VID2 L/MONO and R audio jacks on the back of the TV and to the
Audio Output jacks on the VCR.
C. Connect the video cable to the VID2 V (video) jack on the back of the TV and to the Video Output jack on the VCR.
6. Connect your DVD player to your TV.
A. Connect the audio (white and red) cables to the CMP2 L and R audio jacks on the back of the TV and to the Audio
Output jacks on the DVD player.
B. Connect three video grade cables to the CMP2 Y PB PR jacks on the back of the TV and to the Y PB PR jacks on the
DVD player.
Notes: If your DVD player doesn’t have Y PB PR jacks, but does have an S-Video jack, connect the player to the TV’s
VID1 S-VIDEO jack using an S-Video cable.
If your DVD player doesn’t have an S-Video jack, connect the player to the TV’s VID1 V (video) jack using a video
cable.
Important: If you use the TV’s VID1 S-VIDEO or V (video) jack to connect the DVD player, you must connect the
audio cables to the TV’s VID1 L/MONO and R jacks.
Go to page 15