Filter
Top Products
Connections and Setup
4 Connections and Setup
Digital Audio Out/Coaxial Jack
Use this jack to connect your TV/DVD Player to a Dolby* Digital or DTS receiver or decoder.
*Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.
DTS is a registered trademark of Digital Home Theater Systems, Inc.
Front Panel Controls (from left to right)
If you cannot locate your remote, you can use the front panel buttons of your TV to operate many of the
TV/DVD’s features.
POWER Turns the TV/DVD on and off.
PLAY/PAUSE Starts and pauses disc playback.
STOP Stops disc playback.
REV. (Reverse) Searches backward through a disc while it is in play mode. Press and hold remote control to
go to the previous chapter.
FWD. (Forward) Searches forward through a disc while it is in play mode. Press and hold to advance to the
next chapter.
OPEN/CLOSE Opens and closes the disc tray.
INPUT Toggles through the Video Input Channels [TV (AIR/CABLE), AV1 (SVID), DVD, AV3 (side front)].
MENU Brings up the PICTURE menu.
VOL q Decreases the volume. In the menu system, acts like the left arrow button on the remote control and
adjusts menu controls.
VOL p Increases the volume. In the menu system, acts like the right arrow button on the remote control and
adjusts menu controls.
CH q Scans down through the current channel list. In the menu system, acts like the down arrow button on
the remote control and adjusts menu controls.
CH p Scans up through the channel list. In the menu system, acts like the up arrow button on the remote
control and adjusts menu controls.
Putting Batteries in the Remote
Remove the cover of the battery compartment. Insert batteries, with the polarities as indicated, inside the
compartment. Replace the cover.
Note: If you are not going to use the remote for a long period of time, remove the batteries to avoid damage due to
leakage.