Filter
Top Products
Overview & Setup
4 Chapter 1
Illustrations contained in this document are for representation only.
Overview & Setup
Chapter 1 5
Illustrations contained in this document are for representation only.
IEEE-1394 Cables: 4-Pin and 6-Pin
There are two different types of connectors used on IEEE 1394
devices: a 4-pin style, and a 6-pin style.
The 4-pin connector is capable of sending digital audio signals,
digital video signals and digital control signals back and forth
between devices. The 6-pin connector is capable of sending the
same data and signal information as the 4-pin but has two
Connecting the DVR10
To connect the DVR10 to a 1394 or DTVLink enabled TV, follow these steps:
1. Connect the female end of the AC power cord to the DVR10 and male end into an AC
outlet or surge protector.
2. Connect the 1394 cable to either 1394 port on the HDTV and to either 1394 port on the
DVR10.
additional pins for sending low voltage electrical power. The purpose of this electrical power is to
provide the needed operating power to a device that is not connected directly to the household
AC power such as some camcorders. The DVR10 uses a 6-pin cable but does not supply power to
other devices.
A 6-pin connector cannot be connected directly to a 4-pin jack, and vice versa. To connect a
6-pin device to a 4-pin device, you need to obtain a 6-pin to 4-pin adaptor cable. These cables
are available from electronic and computer stores.
Protect Against Power Surges
• Connect all components before you plug any power cords into the wall outlet.
• Turn off the TV and/or component before you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded.
Connecting Other IEEE 1394 Devices
One of the great advantages to 1394 components is the ability to connect one device to the next
in a single chain. This is known as “daisy-chaining.” Previous audio and video components often
required connections of each component to a single source such as an audio/video receiver or TV.
With IEEE 1394, simply connect one device to the next in a continuous chain using 1394 cables.