Filter
Top Products
4
Follow these steps to add more HDP50 units to your setup.
1. Plug the additional HDP50 unit into an electrical outlet close to the device
you want to connect to the Internet. The Power indicator on the front of the
adapter illuminates.
Important: The Powerlink units work best when plugged directly into an
electrical outlet. Do not plug them into a surge protector, plug strip, or
extension cord.
2. Plug one end of an ethernet cable (not included) into the network in jack on
the Internet-capable device. Plug the other end into the ethernet jack on the
bottom of the HDP50 units.
Within moments, the Link indicators on the additional unit should start blinking.
If it's blinking green or orange, your Internet-capable device is now connected to
your Internet connection. If the Link indicator blinks red or does not illuminate at
all, see the Troubleshooting section in this manual for possible solutions.
Adding More HDP50 Units
Note: For multiple network and advanced set up tips, please visit
www.rcaaccessories.com.