Filter
Top Products
Chapter 5 29
Other Information
Cloning a TV
Use the ClonePRO™ or a master remote to complete any necessary setup steps to the TV, such
as Auto Channel Search, changing Access & Power options, etc. Go to Chapter 1 for more infor-
mation on setting up the TV. When you have finished setting up the TV, you can use it as your
example TV.
1. Connect the ClonePRO™ to the example TV’s DSCI port.
2. It is recommended, though not required, to turn on the TV. Press the POWER button.
3. Press the LEARN button to begin the cloning process. When it is complete, Cloning
Complete is displayed on-screen.
4. Take the ClonePRO to each subsequent TV and then (in either DSCI or IR mode) TEACH
each TV, monitoring the process on-screen.
The settings learned by the ClonePRO™ remain indefinitely, ready to TEACH the next TV until
overwritten by a new LEARN operation.
ClonePRO
™
Troubleshooting
Problems with the DSCI mode
• Make sure the TV is plugged into a live electrical outlet.
• Make sure the ClonePRO™ is plugged into the TV’s DSCI port.
• The connecting cable should have at least 6 wires, mapping 1-to-1 (not flipped).
ClonePRO™ remote isn't working
• Check the battery. Place a new 9V battery in the unit if the battery is old.
• Make sure the ClonePRO™ is pointed at the TV with a clear line of sight.
• If you are trying to TEACH, make sure there is a valid memory stored in the ClonePRO™
(Check by going into DSCI-mode [Status].)