Filter
Top Products
24
Connections & Setup
Set the SAT/CABLE Channel (Autotuning)
The next step lets you set the SAT/CABLE channel. When you set the
SAT/CABLE channel, you’re telling the monitor what channel to tune to
when you press the DIRECTV button on the remote.
Indicate which input you used to connect a satellite receiver, a cable box
or a digital set top converter. If you don’t have one of these
components connected to the monitor, skip this step.
1. From the Channel menu (shown below), select Autotuning.
CHANNEL
1 Signal Type
2
Auto Channel Search
3 List and Labels
4 Autotuning
0 Go Back
2. From the Autotuning menu (shown below), select Set SAT/CABLE
Channel.
AUTOTUNING
1 Set VCR1 Channel...
2 Set VCR2 Channel...
3 Set DVD Channel...
4 Set SAT/CABLE Channel...
0 Go Back
3. From the Set SAT/CABLE Channel menu (shown below), point to the
choice that matches the way you have your satellite receiver, cable
box, or HD receiver connected to the monitor.
SET SAT/CABLE CHANNEL
1 Not connected
2 Channel 3
3 Channel 4
4 Video 1 Input
5 Video 2 Input
6 Video 3 Input
7 (S)VGA 2 Input
8 Component Input
4. Press OK to select it.
Note that the (S)VGA2 input can be used
to connect an HD receiver so you can
receive high definition signals.