Filter
Top Products
4.4 CHAPTER FOUR: TV OPERATION
OPERATION
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (anten-
na) and cable channels. After the available channels are memorized, use the CHAN ▲
and CHAN ▼ buttons to scan through the channels. This eliminates the need to change
channels by entering the channel digits. There are three steps for memorizing channels:
selecting a broadcast source, memorizing the channels (automatic) and adding and
deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify
the type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press MENU•PROG to
display the menu.
2
Press
two times to
select “Channel.”
3
Press
.
The first line of the
Channel menu is
highlighted.
4
Repeatedly press
to
cycle through the
following choices:
ANT (antenna)
STD, HRC or IRC (all
cable TV)
Note: STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
At this point the signal source has been selected. Proceed to “Storing
Channels in Memory” (next page).
1577575A.04 11/15/01 10:32 AM Page 4