Filter
Top Products
References
Trouble Checks
Checks and Adjustments
Press TV to set the remote to control the TV. See buttons on page 6.
Remove batteries and hold down one or more buttons for several seconds
to drain the microprocessor inside the remote and reset it. Re-install the
batteries and try remote again.
Clear the path between the remote and TV of any objects.
Aim the remote at the component you are trying to control.
Make sure batteries in the remote are not dead.
See if batteries are placed in remote correctly. See batteries, page 2.
Press number buttons. Channel may not be in memory. See Autoprogram
on page 19.
Make sure TV/VCR switch on VCR is in the TV position if using VCR.
For numbers over 100, press and hold 1 until 1-- appears, then press the
other two numbers.
Set Cable/Air feature to Cable for channels higher than 69. See page 24.
Check Sleep Timer. See sleep timer on page 21.
Wait 30 seconds and turn on again, a power surge may have occurred.
Check Alarm Off time. See alarm clock on page 22.
Check Alarm On Time. See alarm clock on page 22.
Check clock time. See clock on page 3.
Make sure alarm is turned on or off. See alarm clock on page 22.
Check clock time. See clock on page 3.
Make sure Clock time is set correctly, including AM and PM.
Check Alarm Off time.
Trouble
Remote
Buttons don’t work when
you press them
Remote lockup
Works part or none of the
time
Can’t select certain channel
TV Turns on or off
Turns off by itself
Turns on by itself
Does not turn off at
Alarm Time
28