Filter
Top Products
2
1. Hook up your TV
Details are in the
Connections Guide.
Hook up any antennas, cables or
other equipment to your TV before
you follow the steps below. This is
where to find the instructions for
SVHS, a super VHS recording
format that improves the picture
quality. It is found on some VCRs
and camcorders.
The steps below will get your TV connected and ready for watching.
For more details, see the page numbers listed.
3. Put batteries in the remote
A. Pull off the cover of the battery
compartment.
B. Place the four AAA batteries as
shown, matching the + and –
end of each battery in the com-
partment.
C. Replace the cover.
CONNECTIONS
GUIDE
Use This Book First!
To Find
Your Hook-up
Turn To
Page 1
THIS GUIDE
SHOWS HOW
TO HOOK UP
YOUR TV
AND OTHER
COMPONENTS.
CAUTION: If you choose not to use the stand recommended for your TV, take precautions that the stand
or furniture the TV is placed on is properly located and of adequate size and strength to prevent the TV
from accidentally being tipped over, pulled off, or pushed off. This could cause damage to the TV and/or
personal injury.
Quick Guide to Your TV
Startup
Plug the cord into the outlet,
matching the wide and the small
end of the plug with the outlet.
2. Plug in the TV
A. Plug the cord into the adapter
that was packed with your TV
as shown at the left.
B. Plug the adapter into the outlet,
matching the prongs with the
outlet.
2a. Use this adaptor
for models RBA27550
and RCA27000