Filter
Top Products
Connections and Setup
2 Connections and Setup
Things to Consider Before Connecting Components
Important Stand and Base Safety Information
Choose the location for your TV carefully. Place the TV on a stand or base that is of
adequate size and strength to prevent the TV from being accidentally tipped over, pushed
off, or pulled off. This could cause personal injury and or damage the TV. Refer to the
Important Safeguards sheet packed with your TV.
Protect Components From Power Surges
• Connect all components before plugging any power cords into the wall outlet.
• Always turn off the TV and other components before you connect or disconnect any
cables.
Position Cables to Avoid Audio Hum or Interference
• Insert all cable plugs fi rmly into their jacks.
• Place any Audio/Video (A/V) cables to the side(s) of the TV’s back panel instead of
straight down the back after connecting components.
• Try not to coil any twin-lead antenna cables and keep them away from all A/V cables as
much as possible.
• Make sure all antennas and cables are properly grounded. Refer to the Safety Tips sheet
packed with your unit for detailed information.
Protect Components From Overheating
• Never block ventilation slots in any component. Arrange the components so that air
can circulate freely.
• Do not stack components.
• Allow adequate ventilation when placing components in a stand.
• Place an amplifi er or other hot component on the top shelf of a stand so heated air
rising from it will not fl ow around other components.
20F510TDr.indd 220F510TDr.indd 2 7/28/05 2:06:51 PM7/28/05 2:06:51 PM