Filter
Top Products
25
Speaker Setup
SETUP MENU -- MAIN PAGE
GO TO SPEAKER SETUP PAGE
-- SPEAKER SETUP PAGE --
SET DOWNMIX MODE
OUTPUT MODE 5.1CH SURROUND
2CH STEREO
CENTER 2CH VIRTUAL
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
FRONT
-- SPEAKER SETUP PAGE --
SETUP FRONT SPEAKER SIZE
OUTPUT MODE
LARGE
CENTER SMALL
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
FRONT
-- SPEAKER SETUP PAGE --
SETUP CENTER SPEAKER SIZE
OUTPUT MODE
CENTER LARGE
REAR SMALL
SUBWOOFER OFF
CNTR DELAY
REAR DELAY
TEST TONE
FRONT
-- SPEAKER SETUP PAGE --
SETUP REAR SPEAKER SIZE
OUTPUT MODE
CENTER
REAR LARGE
SUBWOOFER SMALL
CNTR DELAY OFF
REAR DELAY
TEST TONE
FRONT
-- SPEAKER SETUP PAGE --
TEST TONE
OUTPUT MODE
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
ON
OFF
FRONT
-- SPEAKER SETUP PAGE --
BACK TO MAIN PAGE
CENTER
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
MAIN PAGE
REAR
-- SPEAKER SETUP PAGE --
SET SURROUND DELAY
OUTPUT MODE
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
FRONT
-- SPEAKER SETUP PAGE --
SET CENTER DELAY
OUTPUT MODE
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
FRONT
-- SPEAKER SETUP PAGE --
DO YOU HAVE A SUBWOOFER?
OUTPUT MODE
CENTER
REAR
SUBWOOFER PRESENT
CNTR DELAY NONE
REAR DELAY
TEST TONE
FRONT
EXIT SETUP
AUDIO SETUP
PREFERENCES
SPEAKER SETUP
GENERAL SETUP
15MS
9MS
3MS
OFF
5MS
3MS
1MS
OFF
English
The SPEAKER SETUP PAGE provides setup items
relating to surround sound and bass manage-
ment of the audio signals at the analog out-
puts of the RDV-1060.
NOTE
: These settings apply only to audio sig-
nals at the analog outputs. They have no ef-
fect on the digital audio output of the
RDV-1060. In addition, these settings only
apply to Dolby Digital and DTS recordings.
Many of the settings on this screen configure
the number and type of speakers in the sys-
tem. Specifically, there are LARGE and SMALL
settings that determine whether deep bass is
reproduced by the speaker connected to a
channel or redirected to a powered subwoofer.
The LARGE setting is “full-range”; the speaker
will reproduce the entire signal including deep
bass recorded in its channel. The SMALL set-
ting is “high-pass”; the speaker will reproduce
only frequencies above the crossover point
(100Hz). Bass below the crossover will be
routed to a powered subwoofer connected to
the RDV-1060.
In addition, there are settings for delaying the
signal to the center or surround speakers and
a test tone option that provides a pink noise
tone for setting the level controls for each
channel on the external processor.
To reach the SPEAKER SETUP PAGE, use
the CURSOR
buttons to highlight the
SPEAKER SETUP line on the MAIN PAGE. Then,
press the PLAY/ENTER
button.
To return to the MAIN PAGE, use the CUR-
SOR
buttons to scroll down and highlight
the MAIN PAGE line. Then, press the PLAY/
ENTER
button.
The following instructions describe each ad-
justment item on the SPEAKER SETUP PAGE
and the available settings. The default settings
for each item are shown in the illustration.