Filter
Top Products
7-2
Projector Set-up
Highlight ‘Projector Set-Up’ by pushing the control disc up or down and press
ENTER to display the projector set-up menu.
Within the projector set-up menu, the following items can be consolidated or set
to the desired setting :
- Identification
- Total run time
- Change password
- Change language
- Change projector address
- Change baudrate
- Power up mode
Identification
Highlight ‘Identification’ with the control disc and press ENTER.
The ‘Identification’screen gives information concerning :
- Projector address. To change the address of your projector, contact a qualified
service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or com-
patible) or MAC. The baud rate of the projector must be the same as the
baud rate of the connected computer. When there is a difference, contact a
qualified service technician to make the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be
displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the ‘TEXT’key once on the RCU.
- Serial no. : indicates the fabrication number of the projector. This number
can be useful when calling for technical assistance.