Filter
Top Products
4-1
CONTROLLING 4
Caution : Do not display a stationary image with full brightness
and contrast for longer than 10 min., otherwise you risk damage
to the CRTs.
Battery installation in the RCU.
A new battery (not yet installed to save the battery life) is delivered inside the plastic bag
with the power cord. Install the battery as follows :
Remove the battery cover on the backside of the RCU by pushing the indicated handle a
little to the bottom of the RCU. Lift up the top side of the cover at the same time (fig. 1).
Insert the new 9 V battery (type 6F22S or equivalent) in the lower compartment and con-
nect the battery to the contact plate.
Insert the battery into the lower compartment and put the cover back.
Contact
plate
Battery
Behind the
plastic cover,
insert the 'card
for RCU'. You
can cut out the
insert card on
the last page of
the installation
manual.
fig.2
fig.1