Filter
Top Products
7-7
Service Mode
G2 Adjustment
Item is password protected.
Highlight ‘G2 adjust’ with the control disc and press ENTER to con-
tinue.
A safety notice will be displayed on the screen as it is necessary to
open the top cover to adjust the G2.
‘G2 adjustment should be performed by RUNCO personnel, or
RUNCO authorized dealers’.
If you are qualified, press ENTER to continue. If not qualified, press
EXIT to return to the Common settings menu. Further description of
the G2 adjustment is given in the Installation manual.
CRT run in cycle
The CRT run in cycle option can only be activated when memory
blocks on an internal # pattern are available. When one or more
such blocks are available, a flashing white image (5 sec on, 5 sec
off) is generated and that for 5 minutes on the first internal block. In
the next 5 minutes, a second internal block will be used to generate
the flashing white image. The image will also be shifted in a vertical
way to prevent a CRT burn in. To quit the CRT run in cycle option,
press EXIT.
Highlight ‘CRT run in cycle’ with the control disc and press ENTER
to start.
ENTER selects the CRT run in cycle option.
EXIT returns to the Path Selection main menu.
ENTER selects the G2 adjustment.
EXIT returns to the Common settings menu.
ADJUST returns to the Operational mode.
COMMON SETTINGS
CRT RUN IN CYCLE
PROJECTOR WARM UP
MEMORYBANKS : ON
Select with
then <ENTER>
<EXIT> to return.
or
G2 ADJUSTMENT
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
12C DIAGNOSTICS
Select with
then <ENTER>
<EXIT> to return.
or
COMMON SETTINGS
COMMON SETTINGS
G2 ADJUSTMENT
PROJECTOR WARM UP
MEMORYBANKS : ON
Select with
then <ENTER>
<EXIT> to return.
or
CRT RUN IN CYCLE