Filter
Top Products
BNC OUT [R, G, B, H, V] (BNC Terminal
(Output))
BNC (Analog PC) Connection: connecting
the R, G, B, H, V ports.
The number of LCD Displays that can be
connected to the loopout depends on the ca-
bles, signal source, etc. With cables or signal
source where there is no degradation, up to
10 LCD Displays can be connected (May not
be supported depending on the connected
cable).
Note
(Applicable to the DX-2 model only)
BNC/COMPONENT IN [R/Y, G/P
B
, B/
P
R
, H, V] (BNC/Component Connection Ter-
minal (input))
During component input, please check spec-
ifications for the input ports below.
[R/Y, G/P
B
, B/P
R
, H, V]
• [R/Y] --> Red port input
• [G/P
B
] --> Green port input
• [B/P
R
] --> Blue port input
Note
Applicable to the DX-2 model only.
RGB OUT
Note
Applicable to the DXN-2 model only.
LAN (LAN Connection Terminal)
Note
Applicable to the DXN-2 model only.
USB1,USB2 (USB Connection Terminal)
Keyboard / Mouse, Mass Storage Device
Compatible.
Note
Applicable to the DXN-2 model only.
Introduction